Can you put a Great Northern gripper on a Selway quiver?

[julienkoz]

Based on appearances, the answer is no, but has anyone modded one to make this work? I want the Selway slide on because it's solid, but I like the gripper of the great northern quivers and how my 5 arrows bundle into a nice little circle. I fear that with a 5 arrow Selway quiver gripper, they would splay out too much and be annoying?

Any idea? Thanks

[julienkoz]

Well, no responses. I take it nobody has an issue with the way the Selway quivers splay out the arrows in a line? I guess the only way to find out if I don't like it is to buy one and try it out!

[TIM B]

Terry had a selway dirt cheap on the classifieds- wouldn't cost ya much to try
Tim B

[julienkoz]

See if you can link it - I'm not seeing it.

Edit - FOUND IT! THANKS  for the idea!

[Kelly]

My good friend Rick Hinton modified his Selway with a Delta 7 arrow gripper so I see no reason a 5 arrow GN wouldn't work . You will have to make a bracket out of aluminum to both attach gripper to and attach to the part that slides on the limb.

[Steelhead]

Can you cut the steel arm (utility knife for the rubber grippers and hacksaw etc for the steel)and last 2 grippers off of the Selway arrow holder and epoxy it to the back of the steel arm that would be holding 3 arrows now.I think you could.You would have 3 on the outside and 2 on the inside.Not sure about fletch clearance.Might be fine though I think looking at my Selway and imagining what I described with arrows installed.

You would have a 5 arrow setup similar to the GN as far as arrow alignment and geometry.

However I see nothing wrong with the inline design of the Selway.

G.N offers an inline gripper on the Quivers.You dont see em as much though.Some guys prefer those over the original 2 row setup on thier G.N quivers