Backing strip thickness

[YosemiteSam]

Been off the board for a while. I'm building a simple board bow from a maple board. I have a backing strip that is a bit uneven. The thinnest side runs about 3/32" and the thicker side is about right at 1/8". Can this still be used or should I just order a few online somewhere?  I recall the one I got from 3Rivers was right around 3/16" so much thicker.

The plan is to add some reflex at the glue-up. So the backing strip will be doing some work.

[Roy from Pa]

1/8th inch thick will work.

[Pat B]

When I cut backing strips I cut them to 3/16" and by the time I sand both sides they come out about 1/8" or slightly less. I think it will depend on the belly wood you use but 3/32" should be OK for woods that are not too strong in compression like maple, ash or elm and maybe yew or ERC.

[YosemiteSam]

Yes, maple is the belly wood.

[Pat B]

Maple backed maple wouldn't be a bad combo, especially if you added Perry reflex. Be sure the grain of the back opposes the grain of the belly.