2019 what did ya do today....

[Forwardhandle]

That one turned out beautiful Bob glad your getting the bugs worked out that riser wood has very cool grain !

[bigbob2]

Thanks Ritchie. I will have to make a few changes to my form mainly to keep every thing aligned properly but love these bows . 40# is a bit light for my preference but because I Will only be target popping it will be ok, Glad I put those wedges and power lam in too.

[Roy from Pa]

That turned out very nice, Bobby..

[bigbob2]

Thanks buddy, sorry to hear of your loss too mate. Take care.

[Roy from Pa]

Thanks.

[Shredd]

Nice looking lines on the bow, Bob...   Do you have a full draw shot also??

[bigbob2]

Sorry Shred, got no one here to take the full draw shot anymore.

[Roy from Pa]

Ya have a timer setting on your camera?

It delays taking the picture after ya click the button.

[bigbob2]

Don't know Roy would have to check it out and it's bed time here almost 10.15pm. It is only a " point and shoot" camera

[kennym]

That's a sweet one Mr. Bob!!

I spent most of day yesterday getting to my skid loader after the water went down off hwy 36 (4 lane btw) and getting all the water out of it. It got flooded, luckily it only got in the engine and not the hydraulic reservoir or fuel.

Dropped the oil and water out of it and put in a mix of diesel, tranny fluid and engine oil  .  Believe it or not(I still don't hardly) it cranked right up. Ran it about a minute driving it out of the mud it was in , changed the oil again in engine and the chain cases , and moved it farther uphill.  Never assume the water won't get that high because you might get the torrential rains we've had lately...

[Pat B]

You may need to run it a little longer, Kenny, at least until it comes to operating temps to be sure all the water and moisture is out. Lots of water coming down through the middle of the country.

[kennym]

Yep, I'm gonna run it an hour when I bring it home and change oil again...

[Crooked Stic]

Wow Bob very nice. Got this one done yesterday.47@26 50in.

Sent from my SM-J737V using Tapatalk

[Fishinglink]

Wow mike. Good job.


Sent from my iPhone using Tapatalk

[monterey]

I like that riser wood and it goes nice with the lams too.  Is that a custom limb bolt wrench?

[Roy from Pa]

Not too bad there pops...

[Crooked Stic]

Sight window cut out for the limb wrench. drilled a hole in it and routed for the 90 degree part with a dremel tool filled it with smooth on and put a cover on it.

[kennym]

Thought it was a combo wrench/stabilizer.

[monterey]

Yeah, if it was me I'd end up shooting the bow with the wrench stuck in the bolt!

[Roy from Pa]

I thought it was an old timer assist gadget.