Quiver Bushings?

[Full Draw Too]

Good Morning Bowyer Land..
I'm getting ready to put those Quiver bushings on the side of my riser. Do you need to drill and tap a hole for these little guys?and then do you epoxy them in? any help would be appreciated.I think these are the 10/24 style from Binghams..Thanks Guys! I'll wait to hear back from you all...Pat

Acts 4:12

[Roy from Pa]

If they have male threads that screw into the riser, then yes drill and tap it and apply epoxy to the threads would be my guess.. I have never tapped wood but I believe there are special wood taps. But a regular metal tap might suffice for only a couple holes.

[JamesV]

The brass bushings (made by Martin)I install from 3 Rivers don't require tapping the hole. Follow the easy instructions and you will be good. I did put a dab of epoxy on them before installing but the instructions says it is not necessary.

James