Recurve #2

[Nicon]

So a year ago i tried to build a recurve and it was an epic fail. Bubbly as hell and didn't even get to the short string before it went BOOM. Swear to never build a recurve again. So here i go again...  :D
I used the same formula when last time only with less mistakes.

It's 61" ntn, around 46#@28(i was shooting for 40#...) Hoping to lose a few pounds when it's finished.

Some issues though. It has 0,2" positive tiller, but when i pull it on the tillering setup, the lower limb bends about 0,5" less. I pivoted the hook on on the string, where my middle finger would be. I shoot split. Pivot point might raise a little when finished. Should i be worried about the uneven bending or is it close enough, that it could be fixed nock height?
Also have a slight tracking problem. After pulling the string settles about 1/8 past center. Limbs don't seem to bee twisting so i hope it's just uneven nocks. Or is it?
But first i'd like to get the tiller as good as i can. So comments and advice about the tiller would be appreciated.  

   

 

[Al Dean]

You need to get the string to track straight before messing with tiller as you may need to take some off one side of a limb.

[Roy from Pa]

Try this for the string travel.

[Nicon]

I got it tracking by filing the nocks. Only took a few strokes. Still might be off by 1/32 or so. Bit difficult to measure with flemish string.

[LittleBen]

Looks good to me but what the hel do I know ... nothing about glass thats for sure

[bornofmud]

Looks pretty darn perfect to me.  Seems like it's certainly in the range to be able to fine tune with nock placement.

[Nicon]

It's time to finish the bow! How would tru oil work on black glass?