Frist success with fiber glass. a 64" r/d longbow

[GentlemanArcher]

Hi All.

Got out and shot in my latest bow this morning.  I'm pretty please so far.  64" r/d longbow from the Bingham plans.  It pulls 43# at 26 inches.  this morning I shot 29" GT1535s with 100grn inserts and 75 grain points.

I haven't applied any finish yet. I wanted to be sure it was a decent shooter before spending too much time on the finish.

The lams are bamboo (from flooring) and a strip of maple. The glass is .050 and the total taper in the lams is .004/inch.

   

   

 

It shoots well.  Better than I am capable of.  The flyer in the pic with 4 arrows was because I goofed the release.    

I'll update this post when I get a finish on it.  I'm planning on tru-oil and gloss poly.

Kia Kaha
GA

[Sam Harper]

It looks good.  Congratulations!

[GentlemanArcher]

Thanks Sam. Is this Sam from poorfolksbows?...if so, this is actually your fault....my first bow, the one that got me started in all this was a red oak long bow I built following your build a long.

Thanks for all the help!!!!!

[Sam Harper]

I'll gladly take responsibility.  :-)

[Trux Turning]

Good looking bow!! You've got it bending nicely too.  

[jsweka]

I'd say ya done well.

[macbow]

Good solid looking design.

[Glunt]

Lookin' good!

[menatkin]

Nice job!  Givin' me the itch!  Last built a selfbow about 25 years ago.  Been thinking of crafting a R/D for a while now.  May just have to bite the bullet and do it...

[GentlemanArcher]

Thanks everyone.  

Menatkin, it's been a fun process.  It took me three tries to get the correct amount of glue and the clamp pressure strong enough.  But I have to say it feels pretty good to be shooting a bow you made yourself.  I say go for it!

The the next one, I'll plan on making the riser a little deeper (from back to belly) so I can cut the arrow rest closer to center.  Mostly so I have more options on arrows.  

Kia Kaha