Quote from: Mad Max on February 16, 2021, 03:23:40 PM
What edge sander  do you have there Canopyboy?

It's a canopyspecial...

I didn't like what I could get commercially. I wanted a longer platten without getting a bigger sander, so I cogitated on it for awhile in meetings where I couldn't pay attention anyhow and came up with that thing. Works well enough...

 

Ya did well David..

Thanks Max, I understand now.

Bue 

I made a bit more progress today. It's about 2" shy of full draw. A little sanding and shooting in should get it right on. Well counting on it holding up through the shoot in process. It's taken about 1/4" set with about 1/2" right after unbracing. I'm kinda surprised it's held up with so little set and no chrysalling this far. And I like the mass.

Kyle

Just curious, it looks flat through this section.

[attachment=1,msg2952592]

[attachment=2,msg2952592]

It is a little flatter there than I intended. I was hoping to leave that stiff until the last three inches of draw. And just sand the center into draw weight. The stave is 60" between the nocks for a 27" draw. I like to leave the center a bit stiff when I make a bendy handle longer than a 2x draw weight ratio. I do appreciate all critiques of the tiller.

Kyle

Did a little riser work

[attachment=1][attachment=2][attachment=3]

Who are you making that for, Batman 

Can't tell ya

Sweet riser there ole timer:)

Thanks Pops

Nice Kenny.

 

Looking good Kenny!

Quote from: Mad Max on February 17, 2021, 12:42:03 PM
Who are you making that for, Batman 

Nah, check the colors, it's for the Green Lantern

You must become one with your bow🧘‍♂️.And yes I was glued to it, starbond is a wonderful superglue. Deer antler felt like a fitting overlay material on this one. Though I rarely use it.

Kyle

 

I like that riser Kenny!