Been working on this blind limb 3 piece takedown for a couple months.
really focused on the limbs, built a adjustable riser so I can dial in my pad angle and wedge length.
Bow specs are 61.5", 49#@27 In. Draw.
Used 6ply carbon on back with foam and maple core.with fiberglass belly.
Bow braces at 7.25" shoots very fast and quite.

There is also a G10 IBeam in this riser.

This bow now has no finish on it, still tweaking..

Very nice, must have taken a couple of hours to make that one.

That is very awesome....

Quote from: Buemaker on December 29, 2020, 05:55:11 PM
Very nice, must have taken a couple of hours to make that one.

Your Right!  : and I am still not done...

Quote from: Roy from Pa on December 29, 2020, 06:06:04 PM
That is very awesome....

Thanks Roy!

 

Nice looking. Where is the adjustable riser?

 

That is SWEET!!

Quote from: Crooked Stic on December 29, 2020, 07:43:21 PM
Nice looking. Where is the adjustable riser?

Here ya go....
Specs are I can go from a 15 to 21 inch riser in 2in. increments. also
0 to 25 degree limb pad angle.
Setup to be able to shoot an arrow from.
Vince.

Very nice!

Nice setup

How do you adjust the angle

Quote from: OldRawhide42 on December 30, 2020, 08:49:06 AM
How do you adjust the angle

You will see a setscrew in the limb pad that gives it full adjustability.I dial it in using angle finder and set it.
when strung it is very stable.

what Brand mill do you have?

Thanks . I am going to make one of them. Mine will not be as nice as yours is

Thats a looker, love that riser