Just went to the Simmons page to check out the Treesharks again and noticed that they have a new broadhead out.

Has anyone used this head yet? It looks great. What do you guys think?



Jeremy

I did for my spring bear hunt this year. Two shots two dead bears. Both about 60 yards. No tracking needed. Great heads just like all the simmons. I used a 50# at 26" toelke super d

to clarify, recovery 60 yards not shot!

How does it differ from the Treesharks?

Been itching like the weight too!

treeshark is a 2" wide head. This is basically a unvented tigershark. 1 9/16 i believe. 190 grains. A little smaller hole but equally as deadly.

I like the look of that a lot! Might have to pick up a pack since I've already destroyed 2 of the 3 Zwickeys I picked up to play around with.

Look great - wish they were an even 200 grains, not that those 10 grains are likely to matter.

Great looking head

It does look like it would make a nasty hole!

I'm liking them a lot!  Dave must have named them after our swamp adventures down here in South Mississippi and the F.R.O.G Team.

It take a mean head to dispatch a rogue Bullfrog on a charge

I'll probably stick with my treesharks but it's a good looking head! I think they're 1 5/8" cut.

is that a glued in insert or a one piece head,,  all of them spin test perfect no slight wobbles? 

Going to try some of these.

Looks like a Landshark without the vents.

My guess is it is a one piece head. I have a few Simmons heads and they spin true, so I would suspect these will too.

A solid tigershark, 15 grains heavier I believe.

Another great looking broadhead from Simmons.

Just ordered a 3 pack. Hopfully I can test them out on a bear soon.

Jeremy

Ordered a pack of those for my longbow and a pack of makos to try on my other bow

Orderd some yesterday, can't wait to try them Oct 1.