What are some of your favorite hardwoods for Limb wedges and fades on risers.  Not in turns of looks, everyone has their preferences in woods based on looks.  I mean in terms of ease of sanding out to very fine dimensions.  I tried to make some wenge wedges and it didn't work out for me because they were very porous out on the tips.  Bad about sluffing off at the thin edges.  Brittle too.  What are some of the better hardwoods that are reasonably flexible and close grained?  What are some of the hardwoods you try to avoid in these areas?

I have only built 14 sets of ILF TD limbs.  I used Pau Fero on 12 of them and 2 with Zebrawood. I had no problems with either one.

It might be a little on the boring side (compared to "exotic" timber), but I've had good success working with cherry, maple, and walnut when it comes to getting pieces sanded to a very fine tapered tip.

I can see where wenge would be hard to feather. I've done them in about everything from a wood to African Blackwood  to aboo but never wenge

I've used wenge, zebra, cocobolo, bacote, gaboon ebony, and marblewood so far without problems. I like to use bloodwood for power and tip lams because I think it looks cool      

When I doubt, use maple. It's hard, tough, fine grained, minimal pores, cheap, readily available, and classic looking.

With that all said I never faded out wedge like that, but I've never had problems with any other woods.

Have used maple, walnut, various rosewoods, kingwood, cocobolo, shedua, bocote, Ipe and probably other I can't recall.

Bolivian Rosewood also known as Pau Ferro is hard to beat for risers or wedges.  It is absolutely my favorite wood to use.

Thanks for the great info.  I have used maple also it worked very well.  Any others beside wedge I should stay away from?

Padauk could give you problems.  It is also porous and can be brittle. It's great for wider accent strips, but I don't think I would use it in a fade-out situation.

cherry is good--maple and hickory are my favorites

Hard to beat bubinga or Chechen for tight grained, dense risers or wedges.

Exotic woods are very strong and colorful but why not use our sustainable wood supply's in North America like Maple, Oak, Osage, Yew, Black walnut and others. ?
Those Trees cut in the Amazon area will never grow back not even in your great, great grand children's time.

I used Beech wedges with maple core. Looks nice and works great.