Does anyone have any picture of the process? I going to do this to my omega when it arrives.
Thx
Mike

Michbowhunter had a great set of instructions not to long ago.  Should have saved it, been intending to give it a try.

I don't have any pictures of the process but I've done a few. I use a dremel with a good round cutter the size I want the dimples to be. Just outline the area with a pencil and fill the area inside with dots. I use a vise to hold the bow and outline the back (front) of the bow and the shelf area first and work my way down.

what bit did you use?

I picked up a 2-Count Steel Engraving Bit from Lowes- works great!

Here ya go!  Hope this helps.

http://tradgang.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=1;t=105380