I remember seeing a jig that somebody had made for them for drilling takedown risers and limbs that was aluminum. I can not seem to find it and was wondering if somebody could point me in the right direction? Thanks

http://tradgang.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=125;t=006244

I saved it cause I need to get one made, but haven't had time yet.

Looks like it would be great!

Thanks Kenny, this is the most accurate design I have seen yet!  I really had a problem with one limb on my last bow.... I hate to say it but I think it is time!
I will keep you posted.

How does it work on different thickness risers?

I think the second one is the best. You can drill any fade angle and riser length with it. For thicker risers you would need a shim to go under the drilling block.

QuoteOriginally posted by Crooked Stic:
I think the second one is the best. You can drill any fade angle and riser length with it. For thicker risers you would need a shim to go under the drilling block.

Mine is very similar but it has a single center bolt instead of two.  This way the jig pivots and it doesn't matter what the angle is on your riser, so you can change it as much as you want without the need to adjust your jig.