So I got this riser just about shaped up.  I am a little disapointed in the cut out area below the handle where my stripes ran thru.  I wanted to see some accent stripes on the back of the limb pad areas:



But not so happy with the straight lines it is making on the curved area below:



Around the throat does not bother me.. looks like a diagram "put thumb and fore finger here"..LOL..

Any ideas on how to dress this up.. or is it was it is?

Thanks

Just have to make the thicker on the next time.

I think I looks good. As you know you can radius that flat face to some curves in the red lines, or.... You can pull a Ralph ( unhappy with the look of a riser so you cut it way down and build it back up in layers)