A short video that demo's a Young Feather Burner... cool stuff
http://www.youtube.com/watch?v=PauUgYgWEB0

I've been using a Young feather burner for years. I burn my feathers on the front porch when the wind is blowing. d:^)

they are the best!!!
yer right Pat- they sure do make a stink!

I made my own out of a scrap piece of 1x board, some carriage bolts/nuts, and a battery charger.  I bought a few elements from 3rivers.  It works just like the one in the video, except it only cost me $6

Scrub-buster... pics please.  

It isn't pretty, but it works.  The carriage bolts go through the base.  I just put the clamps of the charger on the bolts and the wire heats right up.  The arrow in the picture was done with it.  

 

That's a good looking rig, scrub-buster.

Brilliant, scrub-buster! Great innovation, and for a lot less coin!

No front porch here, Pat B, but next time the garage door will be in the up position, for sure!

awesome scrub buster.

Thanks guys.  It wasn't my idea.  I saw it somewhere else, but I can't remember where.  I think they used a model train transformer for the power source. I think you can also use an old soldering gun if it has the two wires at the tip.

I did like Scrub-Buster a while back and yea it works fantastic. Everyone has a battery charger laying around right?

Just one question guys. How much charger is to much? The only one I own is a 10 amp decreasing charger. Don't want to burn the shop down.
Thanks,
Ed

My charger has two settings, 6 and 12 volts.  I set mine on 6 volts.  I've used jumper cables and a car battery before.  Just try it out for a few seconds and see what it does.  I take one clamp off in between arrows and brush the element off.

Traditional bowhunter had the plans for one with a train transformer years ago.  You can probably find plans for it on the internet.  Yep. 1992 Traditional bowhunter, Bambooarrow.com/burner/html

Thats a cool jig scrub buster!

Mine looked realy old 30 years ago when I got mine at a yard sell.
 I but washers behind where you see the screws that mount the holding device to the burner. So I can put full lenth or full heigth clears the burner a lot better.