Does anybody know what the angle is for your string grooves?  I thought I'd better ask before I strart filing them out.  I've got mine marked at 37 degrees.  That looks about right to me.

D.A.

Mr Krewson will be on shortly to show you how to figure it out I'm sure. Basically if you have an overlay on the back of the bow file that nock out first, then string up the bow and use a pencil to trace where the string lays against the sides of the bow.

I measure 1/2 inch from the tip in, measure 1/4 inch down, draw a diagonal hopefully the right way, make a pilot cut with a hacksaw and widen with a 1/8 inch file. More on my site. Jawge
http://georgeandjoni.home.comcast.net/~georgeandjoni/

Gonna be close enough with an eyeballed 45 degree.

55 degree's works best for me.

I do mine like Eric. This way you always have the right angle according to  the length of the bow. Make sure that all the sharp edges in the string groove are well rounded to prevent string wearing.

----------
Andy

Mine end up kinda like Gregs.

I use a combo square to mark 45 on the limb edge,then round the groove on the belly toward the center of the bow. Ends up with a smooth place for the string at full draw(like Gregs)

Greg, NICE TIP!!

Thanks Kenny,
My string grooves actually use 2 different angles. The inside of the groove(toward the handle) is 55 degree's. The outside of the groove(toward the tip) is closer to 80 degree's. This creates a groove that is wider at the belly side of the limb, which gives room for the string to move at full draw.

Same here, mine may not look that good tho!

I use the chain saw guide to get me started.
http://s562.photobucket.com/albums/ss64/greyhawk39/?action=view¤t=SANY0055-2-1-1-1.jpg" target="_blank">