Ok guys, this might just be my best one yet...Took a bunch of pictures so here we go.

This bow was made for my friend Pete, whom asked for a one piece recurve and will hunt whitetail with it this fall.  

Final specs are 50# @ 28"

First I made the riser. I used a block of desert camo coreflex superaction and I laminated within a piece of Paduak between hard maple.  

 

Once the fades were ground, the first of a few dry runs on the form

 

Out of the oven and rough cut.



Tape off, no bubbles!

Now lets start some overlays...I think I have more overlays on this bow than any other I have made.

All are white glass and paduak

Here are the rough tips

Lookin good,

Sorry for the dual pics...the edit feature is still turned off.  

Here are the handle overlays

Front overlays

Time to make the bandsaw smoke

Time to sand

After I got the tiller down, I sanded to 220 and applied a brush coat of TB epoxy, sanded then applied some smooth on to fill the paduak.  Then another coat or two of TB epoxy with a brush and sanded in between.



Then I applied 3 spray coats of TB, sanding with a scotchbright like 320 grit pad inbetween.  Then the final two spray coats are just frosted to give it that nice matte finish.  

This little touch up sprayer from Harbor Freight is what I use and it just might be the best $10 I ever spent.

And fully finished pics

And I also made a wall rack for this one out of a couple arrows and a piece of Santos Mahag.

      Beautiful, beautiful work. Not your first bow i supose?

Beautiful Bow. Very nice work.

Wow, that is one sharp looking bow!