BBO

bigcountry · April 15, 2009, 11:23:00 AM

Ok, I have a roughed out blank from Mr. McGuire. I am considering backing with boo.

The blanks is pretty straight, not snakey. Its 2" at the fades now and full 2" all the way to the tips.

Would all I have to do is sand it or plane it, to make it flat and glue on the boo? Or is this a waste of a good blank with a sound back and I should just get a core off someone where the back doesn't have to be followed?

ranger 3 · April 15, 2009, 03:37:00 PM

If it is down to one ring on the back why put boo on it?

dave_570 · April 15, 2009, 03:50:00 PM

Why Not ??

bigcountry · April 15, 2009, 03:59:00 PM

QuoteOriginally posted by ranger 3:
If it is down to one ring on the back why put boo on it?

Thought it would be cool to build a BBO. I have built a selfbow. But you may be right. Might make sense just to buy a piece of Osage where the rings are violated.

Pat B · April 16, 2009, 12:38:00 AM

IMO, it is a shame to use a good stave for a backed bow. If you want to build a backed bow get a slat or board.
You can buy a full stave from Mike, saw the belly stave off of it and back that with bamboo. Then take the top half and make a self bow from it.

bigcountry · April 16, 2009, 10:56:00 AM

QuoteOriginally posted by Pat B:
IMO, it is a shame to use a good stave for a backed bow. If you want to build a backed bow get a slat or board.
You can buy a full stave from Mike, saw the belly stave off of it and back that with bamboo. Then take the top half and make a self bow from it.

More I think about it, I think your right. This blank is dead straight. Don't see too many of these.

Bear · April 16, 2009, 03:52:00 PM

Also, a chased ring is probably the last thing that would make a good glue line. You need a nice dimensional slat for that.

Skins and hide are different. But on Mike's stuff you won't even need that... unless you just like it.

ishoot4thrills · April 16, 2009, 04:00:00 PM

Once again, very sound advice from ole Pat B. Two bows from one stave, with one of them being Bamboo backed. Brilliant idea!

bigcountry · April 16, 2009, 04:47:00 PM

QuoteOriginally posted by Bear:
Also, a chased ring is probably the last thing that would make a good glue line. You need a nice dimensional slat for that.

Skins and hide are different. But on Mike's stuff you won't even need that... unless you just like it.

No, if i did it, I would use a planer to smooth it down flat. The boo is pretty flexible.