I have some blades that I just received that have scratches going the length of the blade. Not deep but noticeable. What would be the best way to get them out? Could I start with a 400 sandpaper and go down to a 1000? Thanks in advance!

check out the previous topic below "rusty blade what to do"There is a vary helpful link.  

Get a piece of phenolic or lexan . .something that's not going to waterlog, some waterproof paper in grits as fine as you want to go, & a bottle of Windex.
Cut waterproof paper in strips the width of the block.
Mount the blade in your vise clamped by C clamp to a piece of 2x2 or 2x3.
Wrap the paper strip over the block.(a rubber cushion on the block. ie. a strip of truck inner tube helps.)
Spray the blade w/ Windex
Work the paper in single direction strokes from the ricasso to the point.
Start crosswise on the blade finishing up w/ lengthwise strokes.
Keep an eye on the blade to make sure the scratches from the heavier grits are being removed before changing to lighter grits.
Polishing a blade can easily take as much time as making the entire blade itself.
If it's a working blade I wouldn't take it to much more than 600 to 800 grit.
Any finer & it will show the marks from use.

Patience is operative the word here!!!!!

Larry

Thanks!

Looks like Skullworks didn't trust me... LOL

THIS IS WHY I like a brushed blade LOL.<><

QuoteOriginally posted by RGK:
Looks like Skullworks didn't trust me... LOL

Never hurts to have too much info Ron!!!!  

LOL!