Anybody have any pictures of a simple bandsaw circle jig they like to share? I want to add some spice to my riser.
The simpler the better.
Check this out and see if it helps...
https://www.kennysarchery.com/bow-build
Kenny, with that radius jig, do you still contour sand after sawing or is it clean enough?
I use a jig like Kennys . I cut a 2x4 with the same radius and use that as a sanding block.
Quote from: kennym on November 13, 2021, 09:00:43 PM
Check this out and see if it helps...
https://www.kennysarchery.com/bow-build
Really nice setup Kenny
I like wax paper for my riser blocks :thumbsup:
Had a bit of a hiccup on the maple riser but the walnut one turned out good so far.
Pretty sure I can fix the maple one with patience.
I copied you swing jig Kenny.
Nice... I like that type of accent...
Thanks! It was nerve racking cutting into that walnut. That piece cost as much as a spruce 2x6