SCARF JOINT HELP

[Flem]

In the spirit of the OP, here is another way to get your scarf if you have a table saw, but not a disc sander.
Using the miter gauge slot, I get a 13/16" lap on .200" lams
[attachment=1]

[Jeff Freeman]

Is this knife big enough 🤣

[Mad Max]

No mate you got to have a crocodile dundee knife

[Jeff Freeman]

Dam yours is bigger 😅

[Mike L.]

I always have a hell of a time using my disc sander for scarf joints.  I can't seem to get it to sand a taper 90 degrees.

[Jeff Freeman]

How the heck did that knife get in this post, I'm confused. I think I have a picture of my jig for scarfing the joints. JF