Loose limb pin

[GregD]

I was looking for opinions on what to do with a takedown recurve that has a loose fit on the guide pin. Would you fill the existing hole in with epoxy and redrill the hole or are there better solutions? Any input appreciated. Thanks, Greg

[jess stuart]

If it isn't really loose a bit of wax might take up enough slack. Wax works well on a slightly to loose fit in the locket socket takedown system.

[Wolftrail]

Or spray some clear coat poly into the hole. It will take a few shots but it will fill in the hole a wee bit.

Is not wax a little soft for that Jess...?