Riser length changing poundage?

[traditional beagle]

I've built several T/D bows and have noticed that poundage is affected if the angle or degree of cut where limbs bolt on is changed. My question is if I build a riser 2 or 3 inches shorter than original riser and keep the right degree of angle where the limbs bolt on, will the poundage change? Also, while I'm at it, has anyone had good luck with any other glues for risers that can be bought at Lowes such as Titebond II ? I am out of smooth-on epoxy and hate to invest 30 bucks just for a riser experiment. I'm a tight wad. Thanks, Kirby

[Stiks-n-Strings]

Pat B suggested weld wood which can be bought at about any home supply store. He said the stuff he uses is a two part and alot cheaper than smooth on. and can be air cured. might check it out.

Don't know any thing about your other question all I have built is boo backed or selfbows.

[BenBow]

tb if the limb length stays the same the poundage will increase with a shorter riser. Olympic style bows indicate about 2-4 lbs per 2 inch change in riser length so that could be a starting point.

[traditional beagle]

Thanks, I will check this epoxy out. And as for the limbs, I am going to be using the same limbs. Just thought it might be neat to switch to a shorter bow for hunting out of a ground blind. Wouldn't cost me anything except a little time.

[Pat B]

The Weldwood Plastic Resin is a dry powder that you add water to make the glue. It is a urea glue very similar to Urac. I have used it on backed bows with no failures.

[Pennsyltuckey pete]

Just be carefull when building the new riser.  You will have to have the exact same mounting geometry on the risers otherwise the limbs will be out of square with each other and subject to twisting during the draw.

I think It would be easier to make a shorter set of limbs that are properly tillered on the existing riser.

Just my $.02. Good luck which ever way you go.!

pete