Question about Thunderbird Finish

[BOWHUNTIN FOOL]

I have removed some palm swell on my A&H riser and I would like to reseal the riser . A&H uses a Thunderbird finsh. I dont have access to a sprayer to spray the riser , is there any type of spray "can" polyurathane that I can use over the Thunderbird. Thanks Joe

[TimZeigler]

You can brush on thunderbird as well.  Jim Godden did an article in TBM.  I have it scanned somewhere if your interested in an e-copy.  Tim

[BOWHUNTIN FOOL]

Hey Tim , I would like to see that article. Are you going to make the Rocks Pond shoot in Febuary. Thanks Joe

[Jerry Gille]

I've been brushing on Thunderbird since Tim sent me the article a while ago.  It's work, but if you have the time and patience you can make it come out nice - I'm usually just a little low on the time and patience part...

Spot finishing one time with it will be expensive unless you can talk somebody out of some nearby.

[Holm-Made]

Even the smallest containers they sell will still run you 60.00 plus though.  Research the Massey finish, it is an epoxy finish and will work.  It will cost you about 5 dollars and be just as tough as the TB.  Call me if you need help.  You need to buy Devcon 2 ton epoxy at Walmart and a can of acetone.  Chad

[michaelschwister]

If you use the Massey finish make sure you use a respirator, long sleeves, goggles, and two pairs of rubber gloves. Great finish, but deadly to you.

Mike

[BOWHUNTIN FOOL]

Thank yall for some great info , I am going to try to brush the TBird.