Hickory backed bow kits.

Chris Grimbowyer · February 25, 2011, 07:30:00 PM

What do you guys think about the grain? If the grain run if is bad on the core of an ipe or osage core should I pannic?

PEARL DRUMS · February 25, 2011, 07:56:00 PM

I would like to think that somebody selling bow kits would consider that prior to offering them. But you just never know. Take a pic of the piece concerning you and post it, maybe its just fine.

Robowhunter · February 25, 2011, 10:15:00 PM

Hey guy, This is my first post but I've been a member of the site for over a year. I've learned a bunch from you guys and have built several successful bows and broken my fair share. I've ordered several kits or boards from this guy and have not had one blow up on me yet. I've found it cheaper to order just boards from him and cut my own backing.

Chris Grimbowyer · February 26, 2011, 12:12:00 AM

How long would you guys suggest letting a Hickory backed Ipe glued with titebody 3 dry? And how should I hold them togeather while they are in the form. I made a simple form earlier today. It has a red oak base and 61 inches apart there are 2 by 4s 7 inches high.

PEARL DRUMS · February 26, 2011, 08:28:00 AM

24 hours is ample as long as its not in a 50 degree room. Lots and lots and lots of clamps, about 2" apart. I use c-clmaps on the high pressure areas, fades, handle and tips and a variety of ratchet and spring clamps everywhere else. I have 34 clamps and use all of them every glue up. Alternate sides of the bow as you place the clamps. Ol Roy boy from PA has posted some nice pics showing this, he uses all c-clamps. You need to alternate sides of the bow so the weight of the clamps isnt all pulling on one side of the blank. TBIII sets quick when squeezed down, work smart but dont lolly gag or you will be in trouble. I dry run every bow I glue up just to be sure everything looks good prior to glue. I even place all 34 clamps.

bigcountry · February 26, 2011, 11:19:00 AM

I have bought materials from the guy "kfast", and its good materials. I honestly don't know how the guy is making much money.

Some of the cores wasn't as straight grained as I like. But works.

TroutGuide · February 26, 2011, 12:22:00 PM

Sounds like a great deal if you concider the cost of the tools required for someone to get into producing there own laminates. Wood is one thing but tools are the big investment.

Chris Grimbowyer · February 26, 2011, 12:23:00 PM

I have quite a few tools the only things I could really use are maybe a table saw and a nicholson #49