I installed my bow quiver that I had for long time, a friend gave it to me,
I tried a long time ago to put it on my old Bear Grizzly bow but could not
figure out how to install. fast forward today found the quiver, it took sometime
to think and think and the light blub switch turn on. :banghead: :banghead:
it wasn't that hard :biglaugh: does this look right. I will probably
buy a different one. This is a Kanati quiver [attachment=1][attachment=2]
If it works as they say if it ain't broke......
I tried to center the quiver on the riser. I'm thinking that will work.
looks fine.You might want to move it a little more toward the middle of the bow and just make sure the straps are tight enough.Might be able to move it to a hole that will tighten it up.
Those were nice quivers.Nothing wrong with them at all.
That's what I was thinking, moving it up just a little. I shot with on today,
very quiet, know issues, balance was good
Looks good to me. Nice looking bow too!
Thanks, I bought it from a great guy. his given me good advice.
Looks like you got a great setup there! :thumbsup:
At the end of the fades works.
:campfire: :coffee: :archer2: :campfire: