Here is a Macassar Ebony Sasquatch SS RC with a full overlay with flush limb pockets. The overly on the back and recurve tips is Shedua.
The bow is 60" in length and draws to 32" beautifully with a nice string angle. This one is 48 @ 29"
[attachment=1][attachment=2]
Here is a link to an album with more finished photos.
https://photos.app.goo.gl/tNyJpp8jQCtYU8ueA
Cool lookin bow :clapper:
That wood is spectacular, very nice work. How do you keep the riser from cracking where the thick overlay that flushes the limbs up starts?
Mark
There is nothing to crack, It's a FULL Overlay :laugh:
Look at all the pictures
Quote from: mmattockx on May 26, 2022, 11:08:26 PM
That wood is spectacular, very nice work. How do you keep the riser from cracking where the thick overlay that flushes the limbs up starts?
Mark
Good question Mark....
There are two #8 stainless steel screws that i counter sink and use when i put the initial overlay on with epoxy. That gets covered with the wood overlay.
These are mandatory with a wood riser. Even with an I-beam they flex enough to crack that flush limb pocket without the screws.... Notice the top one is offset for the shelf cut out. This one has a G-10 I beam and most likely wouldn't crack, but fixing it later is a chore, so i use the screws anyway for insurance. Kirk
[attachment=1]
Quote from: Mad Max on May 26, 2022, 11:15:58 PM
There is nothing to crack, It's a FULL Overlay :laugh:
Look at all the pictures
Actually.... that is not correct max.....
[attachment=1]
Looking good as always.
My bad, how thick is that dark piece of wood kirk?
Sorry mmattockx :thumbsup:
Looks great Kirk. JF
Quote from: Kirkll on May 26, 2022, 11:27:29 PM
There are two #8 stainless steel screws that i counter sink and use when i put the initial overlay on with epoxy. That gets covered with the wood overlay.
Thanks for the explanation, that sharp corner has always seemed like a problem area to me.
Quote from: Mad Max on May 27, 2022, 08:01:08 AM
My bad, how thick is that dark piece of wood kirk?
Sorry mmattockx :thumbsup:
No worries, I'm just trying to understand it all. :thumbsup:
Mark
Great work!
Quote from: Mad Max on May 27, 2022, 08:01:08 AM
My bad, how thick is that dark piece of wood kirk?
Sorry mmattockx :thumbsup:
In order to make the center overlay the same as the limb butts I mill extra material when I'm milling the limb components. But... this one has ebony wedges, and bending 1/4" ebony to fit that radius back riser is not practical in one piece, so I milled 2 pcs @ .125. Here is the lay up.
https://photos.app.goo.gl/WV44eoGuKdCAvgbp6
:thumbsup: