Anyone running an Accutune on a Satori and modified the berger hole to get full travel of the shaft? I'm running an Accutune with a Pat Norris springy rest and can't retract it enough to get to centre shot.
I was thinking of countersinking/recessing the berger hole the depth of the head of the accutune to allow it to fully recess into the riser. Just wondering if anyone has already done it.
[attachment=1]
I added plastic washers to the other side of the accutune to pull the rest closer to center.
I still have room for the shaft to travel but the head bottoms out on the riser as it is slightly wider than the berger hole.
I had a similar problem on a samick discovery riser. My solution was to stop being stubborn and just use the springy rest with the provided bolt and ditch the accutune. I love the accutune but it doesn't work well with the springy, which I love more!
Haha, unfortunately I only bought the springs, not the whole rest. I wonder if the Pat Norris microtune has the same issue? Anyway, it's not super critical because I don't think I'll need true centre shot but I've got a couple of mates with access to the right tools to make an accurate job of it so might do it anyway.