Trad Gang

Main Boards => PowWow => Topic started by: Formby on August 25, 2020, 01:29:41 AM

Title: Toelke whip "Apache"
Post by: Formby on August 25, 2020, 01:29:41 AM
Anyone know the suggested nock height for a 3 under Toelke whip?
Title: Re: Toelke whip "Apache"
Post by: acedoc on August 25, 2020, 04:36:03 AM
take a look at toelkes page under customer resources
Title: Re: Toelke whip "Apache"
Post by: Alexander Traditional on August 25, 2020, 06:35:58 AM
5/8"
Title: Re: Toelke whip "Apache"
Post by: Formby on August 25, 2020, 10:39:05 AM
Quote from: acedoc on August 25, 2020, 04:36:03 AM
take a look at toelkes page under customer resources
Only brace heights and recommended draw lengths are listed there.
Title: Re: Toelke whip "Apache"
Post by: acedoc on August 25, 2020, 12:55:09 PM
my bad mate !
Title: Re: Toelke whip "Apache"
Post by: David Mitchell on August 25, 2020, 02:10:24 PM
I just start with a piece of masking tape temporarily wrapped around the string and begin at what I think will be too low and gradually raise the nock until good arrow flight is achieved.  This can vary from person to person depending on different factors, so what one person uses may not work for you.
Title: Re: Toelke whip "Apache"
Post by: Tdaniels on August 25, 2020, 03:35:17 PM
I'm at 5/8 '' also
Title: Re: Toelke whip "Apache"
Post by: the rifleman on August 26, 2020, 07:26:14 PM
In my Whips and Pikas I've always found my best nock tune at 3/4".  I measure to the bottom edge of my top nock set.  Anything lower and i get erratic flight.  Hope this helps.
Title: Re: Toelke whip "Apache"
Post by: Petrichor on August 28, 2020, 04:45:06 PM
5/8 on chinook.
Title: Re: Toelke whip "Apache"
Post by: Chain2 on August 29, 2020, 08:32:42 AM
5/8"