Print Page - riser lam parts for glue-up

Title: riser lam parts for glue-up
Post by: oldfartfarmer on September 23, 2019, 09:53:50 AM

What grit do you sand your riser parts to, on the glue-up side, for a good bond using EA-40

thanks
John

Title: Re: riser lam parts for glue-up
Post by: Shredd on September 23, 2019, 12:23:59 PM

60 for everything unless I am using Zirc then I use 80...

I

Title: Re: riser lam parts for glue-up
Post by: beachbowhunter on September 23, 2019, 01:00:07 PM

80 for all

Title: Re: riser lam parts for glue-up
Post by: Flem on September 23, 2019, 01:26:34 PM

I go to 120 or 150, but I like a tight fit.

Title: Re: riser lam parts for glue-up
Post by: Roy from Pa on September 23, 2019, 02:01:49 PM

Title: Re: riser lam parts for glue-up
Post by: oldfartfarmer on September 23, 2019, 02:08:39 PM

THANK you ALL,
sorry for all the questions but ive never built a Bow before

Trad Gang