A while back someone was running a Great Northern Quick Detach quiver that enabled you to use antler burr take down knobs on a 3 pc TD. I think is was 2 washers sandwiched together with a hole in them, that allowed the quiver wire to seat there, making it easy to tighten the burrs. Not the bracket that comes with the quiver/
Anybody got something similar or a solution That they are running?
What you are describing sounds like the original washers before the QD system? I haven't found a way to use the QD with Burr bolts. I have 3 or 4 GN's and have one set up for burrs and the others are bolt down with QD so I can swap quivers as needed without taking the bow down.
John
This is the point, I asked Bob Brimm to make some longer attachments to accomodate some antler knobs, but brobably the requests are too low. I drilled some bigger holes on the attachments and filed a little bit of material out to lower the rise that interferes with the knob. The other solution is to use the 2 original washers but in this way you have to unstrung the bow for set the quiver.