Print Page - Footing a GT Warrior 500 spine

Title: Footing a GT Warrior 500 spine
Post by: Charger83 on November 25, 2018, 10:38:37 PM

I was wondering if anyone knew what size Aluminum shaft you would us to foot a goldtip Warrior 500 spine

Title: Re: Footing a GT Warrior 500 spine
Post by: TwistedHollow on November 28, 2018, 04:16:43 AM

2117's should work for them

Title: Re: Footing a GT Warrior 500 spine
Post by: TIM B on November 28, 2018, 06:27:22 AM

Watching this as I also shoot some warriors....have had good luck w them despite them being a more economical shaft.
Tim B

Title: Re: Footing a GT Warrior 500 spine
Post by: the rifleman on November 28, 2018, 10:16:43 AM

Inside fit range Outside diameter Shaft size ID Spine Spine Shaft ... - Outdoorcore
PDFoutdoorcore.com › arrowdata › arrowfit1

This site is a pdf with all common aluminum inside diameters.

Title: Re: Footing a GT Warrior 500 spine
Post by: Charger83 on November 28, 2018, 10:20:38 AM

Thank you very much for all the help

Title: Re: Footing a GT Warrior 500 spine
Post by: the rifleman on November 28, 2018, 10:23:49 AM

Looks like the gold tips are .290 and 2117s are .2941. they should work well. I use a reloaders chamfer tool to bevel inside and outside of the alum footing.

Title: Re: Footing a GT Warrior 500 spine
Post by: Charger83 on November 28, 2018, 01:08:54 PM

Not a bad idea I was try to think of a way to taper

Trad Gang

Main Boards => PowWow => Topic started by: Charger83 on November 25, 2018, 10:38:37 PM