I have about 3 dozen 2117 which are my all round go to arrows for several bows. They need to have fletch removed and redone. Who has a tool or process to accomplish that?
Anyone offer reflecting?
I just cut the top out of a 16 to 24 oz water bottle, put a bundle of shafts in it nock down, and fill with acetone. Feathers and nocks come off easily.
!!where is the easy button?? Thanks.
Always happy to help fix up Old or new shafts
ttt
I use a Pro Arrow fletch stripper made by Cir-Cut Archery. Takes the wrap and fletching off in no time. Wipe off any residue with acetone, and you're good to go.
they are aluminum..no worries if you use a utility knife. That's how I did mine for years..cant use one on carbon but on aluminum you will be fine.
Quotethey are aluminum..no worries if you use a utility knife. That's how I did mine for years..cant use one on carbon but on aluminum you will be fine.
X2. I use those razors you get at the hardware store with the "safety edge" on one side...... Peels off any feather I've ever used, along with the glue. :thumbsup:
A piece of 1 1/4 black pipe about 10 in. long with a cap screwed on one end
. Can get half a dozen in there with lacquer thinner or acetone. soak for about 1 hour and most stuff will come off including wraps.
Is it OK to use acetone on woodies?
Quote from: Hopewell Tom on May 15, 2018, 06:35:18 AM
Is it OK to use acetone on woodies?
Acetone will most likely damage/dissolve the finish and or cresting...and will probably do that before it even starts to soften the glue.
Thanks, I didn't think it would work. I will get to some old aluminums I was looking at just last week.
I use potato pealers on any type of shaft material. Just lay it flat before the feather lip and drag towards the nock. Then just run it up and down, until any glue or feather residue scrapes off. Never even notice it after I finish, rub with a little iso alcohol and ready to re fletch. Cheap, quick and easy! Hope that helps! Pat