Does anyone have any picture of the process? I going to do this to my omega when it arrives.
Thx
Mike
Michbowhunter had a great set of instructions not to long ago. Should have saved it, been intending to give it a try.
I don't have any pictures of the process but I've done a few. I use a dremel with a good round cutter the size I want the dimples to be. Just outline the area with a pencil and fill the area inside with dots. I use a vise to hold the bow and outline the back (front) of the bow and the shelf area first and work my way down.
what bit did you use?
I picked up a 2-Count Steel Engraving Bit from Lowes- works great!
Here ya go! Hope this helps.
http://tradgang.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=1;t=105380