I need to buy a 10" table saw blade to cut the pads for takedown risers. It will be a Feud diablo blade but I'm not sure if I should get the 40 -60 or 80 tooth blade. Two inches of actionwood is a bear sometimes. What would work best. Thanks, Don
On Awood, I have much better luck with fewer saw teeth. I use 24 t for everyday work.
It tends to gum up on the high tooth count.
I'd go with the 40-60 if I were doing it. JMHO
I use the 40 tooth general purpose blade.
Thanks guys, I think I will get the 40 tooth. Don