Just wondered what glue you all used when you make laminated riser blocks? I have some titebond III, but being new at this, I wasn't sure if I needed something else. Thanks!
If it is going to be a glass bow I would use smooth-on
Like Trux says, if its glass EA40 Smooth-On Epoxy, an industry standard.
Smooth-on for glass and Urac or Resorcinol (sp) for all wood bows.
I don't think I would use titebond on a bow. Like everyone else has said I wouod go with smooth-on or Urac, I have used smooth-on and have had no problems with it.
I used TB111 on a few risers and they all held up so far, but for the little savings it isn't worth the doubt. Smooth-on is your best bet for glass bows.
James............
I agree with everyone. I used tite bond III on one of my very first bows to have it blow up. I have used smooth on ever since with NO problems.
I have used the Titebond 3 on several risers without an issue. That doesn't mean that I would recommend it or that I will not have problems with those risers in the future. I could only recommended the same epoxy as the others have mentioned above.
I like Smooth-on.