Have a question. What size dowels and spacing do you use on your forms? Pine or hardwood dowel?
I used hardwood on mine and I spaced them every 1-1/2 inches but I think you could space the 2 inches and be ok. and I use 3/8 in dowels with a 3/8 in drill bit. They dont fit in tight so I glued them in and the pressure seem to hold them in to. Hope this helps
p
i've got 5/16"dowels w/3/4" sticking out on each side of the form
i've seen guys w/ way thicker dowels--but i had the dowels and used them -worked out fine---in fact on one form i have deck screws instead of dowels--and it works fine also
I use 3/8 hardwood dowels and they stick out approx one inch. So far I ripped apart some rubber bands but never had any problems with the dowels. The dowels are spaced about 3 inches and I get very nice glue lines with it.
http://tradgang.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=125;t=002608;p=2
----------
Andy
i use 1/2" oak dowels and most stick out 1" or a little more. around the handle they stick out more like 2 to 2 1/2" so i can get more bands on it. i've had no problems with mine.
I'm not saying that my method is the safest way ;) , but I don't use dowels on my current form. I just wrap the bands all the way around the form. I feel relatively safe doing this because I use a liberal amount of filament tape on my form to secure the bands.
Now that I wrote that, I'll tell you that my next form will have dowels drilled into it! Doing it this way will enable me to use fewer bands with more coverage.
I use 1/2 " oak dowels that extend 2 inches out of the form on each side. For the rubber bands I use inner tube bands or my new favorite which are pallett rubber bands. 3/4 of an inch wide and 72 inches long.
pete
i dont use any dowels. I find it works better if you go all the way around your form.
(http://i727.photobucket.com/albums/ww279/sulphur7/Gammill%20Longbow/DSCF2417.jpg)
Here is a picture of the form that I've been using for 3 pc take downs.
(http://i872.photobucket.com/albums/ab287/Pictures4scott/takedownlimbonform.jpg)
Tonight I started working on a one piece form. I just need to use a router to clean up the edge and then it will be time to glue up some more fun! I may end up using dowels on this form but who knows? If a dry run works out well I may just wrap this entire form too.
Scott