Print Page - Sanding ((How fine))

Title: Sanding ((How fine))
Post by: toot on January 04, 2009, 04:35:00 PM

I'm in the process of redoing a hoyt huntmaster..

..........VOODOO STYLE.....................

How fine is it neccessary to sand on the riser..

I've always went high gloss before but...

I want this to look like satin glass..

Mirror smooth but satin finish..

I've sanded down with 320 grit, and it's very smooth and the laminate lines are very sharp..

I can just see (when I look real close) some very small pores.. Should I not even wory about these minute pores??

Should I spray-sand-spray-sand, and be done with it..

Thanks, Toot

Title: Re: Sanding ((How fine))
Post by: bjansen on January 04, 2009, 06:32:00 PM

If it were me I would leave it at 320, and apply your sealer coat...that should fill in the pores and if not your next spray coat will..then a couple more finish coats and you are done. best of luck

Title: Re: Sanding ((How fine))
Post by: Apex Predator on January 04, 2009, 07:19:00 PM

I only sand to 220 when spraying fullerplast catalyzed varnish. The pores will still need to be filled by spraying and sanding no matter how fine you sand it.

Title: Re: Sanding ((How fine))
Post by: toot on January 04, 2009, 09:28:00 PM

O.K..

Thanks people..

Toot

Trad Gang

Main Boards => The Bowyer's Bench => Topic started by: toot on January 04, 2009, 04:35:00 PM