Hey all:
I am working on a few knives and I feel it would be cool to put my mark on them. Does anyone know where to get a metal stamp from? I am not looking for the run of the mill block letter but rather a cool design of an "S" as it is my last initial. or even if someone knows who makes custom stamps.
I will try to post a picture of one of my blades in the making soon.
Thanks
(http://picasaweb.google.com/csscully/Knives#5350365357235281570)
Blade length 2.75"
O.A.L. 7.0"
5/32" thick
D2
Handle will be Dymondwood and micarta with fiber spacer between handle and steel with brass or N/S pins.
If you can't see the pic please go to the following URL
http://picasaweb.google.com/csscully/Knives#5350365357235281570
http://www.steelhandstamps.com/
http://www.henryaevers.com/
These are two that I know of, probably more out there.
Nice looking blade ya got going there. If you go to your picasa page and right click on the knife image and then click on "properties" it will show the address to the image itself that you need to link to for it to show up here.
(http://lh6.ggpht.com/_zlyc1WA1cFA/SkBQ8eiQnqI/AAAAAAAAABc/pCeukwHzqyY/Bunny%20001.jpg)
Thanks Wampus, for both the info on the stamps and the comment on the knife.
TBRA
Well, I finally got some time in the garage and was able to finish up the rest of the knives and get them to the heat treaters. Now it is time for the handles. I have decided to try natural exotic woods this time to see what happens. Here are a few that I will try to get shaped and put on a couple of knives today.
http://picasaweb.google.com/csscully/Downloads#5369430363134980354
From top right to left the woods are:
Mesquite burl that chevrons into Bfrican Blackwood.
Mesquite burl
Bacote that chevrons into Blackwood
Osage that chevrons into Blackwood
more Mesquite burl
thanks for looking
http://picasaweb.google.com/csscully/Downloads#5369437863937927794