Print Page - what size holes in tang

Title: what size holes in tang
Post by: Dmaxshawn on May 20, 2008, 06:28:00 PM

Hey guys this is new to me I was just wondering what size holes do you drill in the tang for the brass pins? thanks

Shawn

Title: Re: what size holes in tang
Post by: Lin Rhea on May 20, 2008, 07:16:00 PM

Shawn,
If I use a 1/8 pin, I drill a 1/8 hole. That's what I do. Lin

Title: Re: what size holes in tang
Post by: Dmaxshawn on May 20, 2008, 07:34:00 PM

thanks I guess I should have asked what size pins.

Shawn

Title: Re: what size holes in tang
Post by: Lin Rhea on May 20, 2008, 07:46:00 PM

Shawn,
I fasten my handle in several ways. Most of the time I use pins of some sort. Different sizes. Lin

Title: Re: what size holes in tang
Post by: skullworks on May 21, 2008, 07:38:00 AM

I go from 1/8" up to 1/4". I have used brass, copper and mosaic pins. I've seen people use rivet shafts, bolts, just about anything will work I guess.

Trad Gang

Main Boards => Hunting Knives and Crafters => Topic started by: Dmaxshawn on May 20, 2008, 06:28:00 PM