Print Page - Beman Centershot and Axis Trad shaft outside diameters ???

Title: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: Sapcut on February 22, 2018, 06:48:00 PM

When searching, i only see the point size but not actual outside diameter sizes.

Anyone have this info handy? Thanks

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: drewsbow on February 22, 2018, 07:59:00 PM

axis are .262
beman are .279

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: Sapcut on February 22, 2018, 09:32:00 PM

Thanks. Is that for all spines or only specific ones ?

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: TomMcDonald on February 22, 2018, 11:39:00 PM

All internal diameter would be the same, external diameter would vary for spines.

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: JRY309 on February 23, 2018, 09:10:00 AM

If you are looking for point size,Saunders make 17/64 points for Axis up to 125 grs..PDP used to make points for Axis a 9/32 that tapered down to 17/64 at the base to make a smooth fit on Axis up to a 145 grs..As for Beman Centershot's they use a 9/32 point.

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: Sapcut on February 23, 2018, 02:26:00 PM

Thanks

Im looking for the specific ODs for proper footing sizes.

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: olddogrib on February 23, 2018, 03:14:00 PM

Not to hijack the OP's thread, but since his question got answered, is the ID of the Beman Centershot such that they'll accept the same inserts and nocks as the GT trads and ICS?

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: JRY309 on February 23, 2018, 03:54:00 PM

No they won't,the ID of an Axis is .204 that uses a X-nock,the ID of a Beman Centershot is .233 that use a H-nock and the ID of GT and ICS is .246 that use a S-nock or some call a S-type nock.

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: drewsbow on February 23, 2018, 08:56:00 PM

mine are on 500's

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: Sapcut on February 24, 2018, 12:31:00 PM

Thanks Drew

Title: Re: Beman Centershot and Axis Trad shaft outside diameters ???
Post by: drewsbow on February 24, 2018, 08:30:00 PM

:thumbsup:

Trad Gang

Main Boards => PowWow => Topic started by: Sapcut on February 22, 2018, 06:48:00 PM